Tooling
Compact Cutter - HLK-33800
This compact cutter is a double acting device capable of cutting steel wire rope up to 1 Inch (25mm) diameter and steel bar up to 1/2 Inch diameter. The shaped closure for the cable allowes it to cut the full diameter in one pass.
The unit comes with an intensifier allowing operation from a 140 Bar supply. Weight in water is approximately 8.2kg in water.Various mounting options available.
Standard Cutter - HLK-33900
The HLK-33900 standard cutter is a double acting device capable of cutting steel wire rope up to 1.5 Inch (38mm) diameter and steel bar up to 1 Inch diameter. The cutter has a shaped closure for the cable such that it will cut full diameter in one pass. The unit comes with an intensifier allowing operation from a 140 Bar supply. Weight in water is approximately 14.3kg. Various mounting options available.
4" Disk Cutter - HLK-33600
The Hydro-Lek 4" cutter can be operated directly from a work class hydraulic supply or from a system comprising of the HLK-90200 and 9200 Power packs or HLK-90100 Dual Power Pack, HLK-7020 Valve Pack or HLK-72100 and control system. The cutter jaws grab the hose or cable to be cut and then a rotating disc is fed onto the job to be cut. The grip is so strong that even in zero visibility and locked on, a perfect cut can be easily achieved. Weight 12Kg in water.
6" Disk Cutter - HLK-33625
The HLK 33625 6" Cutter is a self-contained grab, feed and cut unit, which for a weight of only 14kg can cut pipe, cable or grout hose. This is a significant weight reduction on standard anvil cutters. It can be controlled using standard Hydro-Lek systems or directly from a work class ROV.
Suction Pump - HLK-3150
The HLK-3150 Suction Pump is a compact Venturri device designed to provide controlled flows for suction anchor installation and removal. Together with the HLK-3100 Water Jet it can be fitted to the smaller ROV's, either within the frame or skid mounted. This enables suction tasks as well as jetting in one package.
Sub-sea Drill - HLK-3200
The HLK-3200 Sub-sea Drilling System was designed for drilling holes so that sacrificial anodes could be fitted under water. It uses a heavy-duty magnet to hold the drilling system in place, while a hydraulic motor rotates the drill. An HLK-1080 Cylinder with a flow control valve pushes the drill carriage down the guide rods to drill the hole.
Water Jet - HLK-31020
The HLK-31020 Water Jet, has been developed to assist in cleaning tasks needed on many sub-sea structures before intervention. Driven by a 3 phase motor, the pump can deliver 12.5 litres per minute at 110 bar, though an orbital nozzle. The nozzle can be deployed by a manipulator or fixed on the ROV and directed by the ROV itself.
Submarine Rescue Drilling Machine - HLK-32000
This device was developed in the aftermath of the KURSK disaster to enable emergency air to be applied through the hull of a stricken submarine.
Manipulator Camera Conversion - HLK-2010C
The HLK-2010 can readily be converted to a camera platform for fitting to any HLK manipulator. This conversion can be carried out on site without any change of hydraulic hoses. As with the jaw assemblies, the standard finish position of the camera pan platform is adjustable on the clamp mount. Weight 3 Kg in water./p>